Alignment Tool, Crankshaft Position Sensor 303-507 Timing Peg, Crankshaft TDC TKIT-2001N-FLM Ford Diagnostic Equipment Removal. NOTICE: Do not loosen or remove the . crankshaft. pulley bolt without first installing the special tools as. instructed in this procedure. The crankshaft pulley and the crankshaft timing sprocket are not keyed to the All XR5/ST and RS models require coolant that meets or exceeds Ford specification WSS-M97B44-D. It is normally Pink/Red or Orange in colour. How do I replace the rear park light/indicator/brake light bulbs? Open the rear tailgate hatch and remove the 2 Phillips headed screws holding the light assembly in place. Gently tug the light assembly Failure to follow this instruction will cause damage to crankshaft position (CKP) sensor hole. NOTE: Only rotate the crankshaft in the normal direction of rotation. NOTE: The special tool must be fully inserted. Insert the special tool through the CKP sensor hole to achieve 50 degrees before top dead center (TDC). April 14, 2020 by Jason. P0344 is an OBDII diagnostic code. It is a generic code, which means that it has the same meaning for the Ford Mondeo as it would any other vehicle. If your Mondeo has this code, it means that the PCM (powertrain control module) has detected that the camshaft position circuit is sending an intermittent signal. the sensor is positioned right at the top of engine directly above the cam cover as such. should be one 8mm head bolt holding it in place easy enough to get out . but you need to remove the cam cover fitting the new sensor. the new sensor should have a small protusion that buts up to the back of the cam sprocket webs. that gives the correct clearance then pinch bolt up. the protrusion wears off. Buy Now!New Crankshaft Position Sensor from 1AAuto.com http://1aau.to/ia/1AECS00082The crankshaft position sensor is an important component of any electronic YgvPsF2.